Remote ADB lets you run ADB (Android Debug Bridge) commands wirelessly from your phone to other Android devices — no root required. Whether you're using Android 12+ with built-in pairing UI or older Android versions, this app simplifies wireless debugging and remote control.





? Features:

• ? Connect to devices over Wi-Fi (ADB wireless debug)

• ? Pair devices via ADB Pairing Code (Android 12+)

• ?‍? Run shell commands directly from your phone

• ? Support for both modern and legacy ADB connection methods

• ? No root required, minimal setup





? How to Use – Android 12 and Above:

1. On the target device, go to:

    Settings > Developer Options > Wireless Debugging

2. Enable Wireless Debugging

3. Tap “Pair device with pairing code”

4. Open this app on the controller device – it will automatically scan and detect nearby devices

5. Tap the detected device → Enter the pairing code → Done!

6. Now you can send ADB commands from your phone






? How to Use – Devices Without Pairing Mode (Android 11 and below):

These versions do not support built-in ADB pairing UI, but you can still connect wirelessly:

1. Connect the target device to a PC via USB

2. On your PC, run the command:

    adb tcpip 5555

3. Disconnect USB – now the device listens for ADB over Wi-Fi

4. Find the device IP from Settings > About > Status

5. Open this app → Enter IP:5555 and connect

6. You're now ready to send ADB commands remotely


Note: Ensure USB Debugging is enabled on the target device.





⚠️ Requirements:

• Developer Options and USB Debugging enabled on the target device

• Wi-Fi connection (both devices must be on the same network for pairing)





?️ Disclaimer:

This app requires technical knowledge of ADB and is intended for developers, testers, and power users. Use responsibly.