With the (BALLUFF) NFC Toolbox app, your next setup of NFC-enabled BALLUFF hardware will be a breeze. But the NFC Toolbox app will not only assist you during the initial setup, it will also help in maintenance cases when it comes to restoring a device to its original state or even completely replacing it. If a device needs to be replaced, its last parameter set can be easily copied to a new device.



Initial Parametrization:
Simply open the NFC Toolbox app, hold your phone up to the device to be parameterized, and press read. In the following menu, select "Module settings," adjust the parameters, and transfer them to the device by pressing write. If necessary - restart the device – setup complete.



Factory Reset:
Open the NFC Toolbox, hold your phone up to the device, press read, select Factory Reset, wait & confirm.



Device Cloning:
Read the defective device with the NFC Toolbox, hold your phone up to the new device, press write to transfer the read data set, and, if necessary, restart the device – done.